Fuel tank 64 oz Top mount Gas Tank with Mounting Bracket hardware. Be sure and print off or refer to these instructions when installing the tank.
Fuel Tank - Gas Tank, Holds approximate 64 oz of fuel. Comes complete with 2 lines approximate 20" long.
The Yellow line (has a fuel filter on the end of the line in the tank) goes to where the BLACK line was on the carb. The clear line goes where the clear line was.
Includes the fuel cap. It has two mounting flanges that are about 9.5" apart.
About 4" Wide, 10 - 1/2" Long including the mounting flange, 7" Tall including the plastic cap.
This tank will extend the range from the standard tanks about 3 times.
You can add this tank kit regardless of the brand, size, Four or Two Cycle engines.
Includes the 1/8" x 1" x 3" long Zinc Plated bracket and a 1/4-20 x 2" long Eye Bolt with hardware for mount to the top of the friction drive channel. This bracket is held on with the 3/8-16 x 6" long tap bolt.
You will have to turn the keps nuts a little at a time as you turn the bolt to work them together.
Includes Five Steel Bond Rubber washers to hold the tank plus all mounting hardware.
You will need to drill a 1/4" hole on the channel for the Eye Bolt.
If your channel is not drilled, measure from the Left side - Rear of the channel over 2-1/4" to the right and from the bottom up to the center of the hole about 1/4" to 5/16".
Most of these small engines 25 to 50 cc will get from 160 to 240 mpg.
64 oz of fuel could run from 80 to 120 miles per tank.